Then you can guess at the Rx and Tx lines. Some boards are NOT marked with pin designation, so use a multimeter to determine power and ground to avoid shorting the serial cable TTL chip. There are three or four connections for serial to function properly: Vcc (+3.3V, but usually not connected), GND, Tx and Rx. Serial cable can be either USB or DB9 connection type and be capable of voltage level shift to +3.3V, not +5V. Some routers have serial ports inside the WAN port, and here is a link to some Serial port pinouts.

Unless it has an OEM header, you have to either solder the wires to the pads, or remove solder from the holes to install an appropriate header. Serial ports are normally four or five pins on the router board. The last resort is to desolder the flash chip and use a programmer to flash CFE (if needed) and firmware. Otherwise JTAG is required to debrick, if available, which can also replace a corrupted CFE. Java programs can use the RXTX library.Routers with a serial port AND working CFE (bootloader) can often be recovered with a serial adapter, using CFE low-level commands. The Qt framework provides the QSerialPort class. NET framework supports serial port communication with the System.IO.Ports.SerialPort class. Windows, Linux, and Mac OS X all provide C APIs for serial port communication. You can also write your own computer program to use the serial port. If you need to send and receive non-ASCII bytes, you can use the Pololu Serial Transmitter Utility for Windows. Bytes received by the programmer on the RX line will be displayed on the screen by the terminal program. The characters you type will be transmitted on the programmer’s TX line. To use any of these terminal programs with the USB-to-TTL-serial adapter, you must specify the port name determined above and your desired baud rate. Advanced users developing scripted applications might prefer the free terminal program kermit. There are many free terminal programs available, including PuTTY (Windows or Linux), Tera Term (Windows), Terminal (Windows), and screen (Linux or Mac OS X). You can look in the upper left corner of the Pololu USB AVR Programmer v2 Configuration Utility, or you can run pavr2cmd -ttl-port, or you can follow the instructions in Section 4.5.Īfter determining the port name, you can use any serial port software to communicate on that port. To use the USB-to-TTL-serial adapter, you must determine what port name the operating system has assigned it. The programmer’s voltage regulator controls what voltage it will be using, and the regulator settings are described in Section 7. To make a working serial connection between the programmer and another device, you should make sure to run the programmer at a voltage that is equal to or close to the voltage of the other device. The following figure is an example of an 8N1 TTL serial byte transmitted at 5 V:

The programmer supports all integer baud rates from 300 to 115200 bits per second. All devices involved in asynchronous serial communication need to agree ahead of time on the duration of one bit (the baud rate), so all devices must be independently configured to run at the same baud rate before they will be able to communicate with each other. The bits must be non-inverted, meaning that a zero is sent as low voltage, and a one is sent as high voltage. This coding is sometimes abbreviated 8N1. The bytes are sent and received eight bits at a time, with the least significant bit first, with no parity and one stop bit. When the programmer receives a byte on the RX input line, it will send that byte back to the computer via USB.

When the programmer receives a byte from the computer via USB, it will transmit that byte on the TX line. The TX and RX lines of the programmer are used to perform asynchronous serial communication. This feature is similar to our CP2104 USB-to-Serial Adapter Carrier. The USB-to-TTL-serial adapter looks like a standard serial port to the operating system, allowing you to use existing terminal programs and software designed to use serial ports. One bonus feature of the Pololu USB AVR Programmer v2.x is the USB-to-TTL-serial adapter, which can be used for connecting microcontroller projects to a personal computer.

Windows serial terminal programs